61
CHAPTER 6 INSTALLATION AND WIRING
6
6.5 Wiring of Ethernet Cable
● The time taken for the LINK LED to turn on after connection of the cable may vary. The LINK LED normally turns on in a
few second. However, if link-up processing is repeated due to a condition of a device on the line, the longer time may be
required. If the LINK LED does not turn on, refer to the following and take a corrective action.
Page 183, Section 11.4.1 (8)
● PORT1 connector and PORT2 connector need not to be distinguished. When only one connector is used in star topology,
either PORT1 connector or PORT2 connector can be used.
● When two connectors are used in line topology or ring topology, there is no restriction on the connection combination of
PORT1 connector and PORT 2 connector. For example, the connection from PORT1 to PORT1 and the connection from
PORT1 to PORT2 are both possible.
(b) Disconnecting
1. Power off the module.
2. With the latch of the Ethernet cable pressed, unplug
the cable.
Connection from port 1 to port 1,
and from port 2 to port 2
Connection from
port 1 to port 2
To Next Page
Loading...
