6 INSTALLATION AND WIRING
6.6 Wiring of Connector for Module Power Supply and FG
131
6
When using a cabtyre cable, strip the jacket of the cable by 2cm or more. If the wires are uneven in length, cut
the ends of the wires to an even length with a tool, such as a nipper, before inserting them to the connector.
Precautions
When modules are transition wired through connectors for module power supply and FG, a current flows in the modules.
When applying transition wiring, design the system so that the current that flows in the modules is equal to or lower than the
allowable current value of each module.
2cm or more
Trim the wire ends to the same length
To Next Page
Loading...
