APPX
Appendix 2 Remote Register
233
A
Function selection status area
■Device number
■Description
The setting status of the function is shown.
■Input response setting status (RWr2.b0 to RWr2.b2)
The setting status of the input response setting function is shown.
■Output HOLD/CLEAR setting status (RWr2.b3)
The setting status of the output HOLD/CLEAR setting function is shown.
■CC-Link IE TSN Network synchronous communication setting status (RWr2.b4, RWr2.b5)
The setting status of the CC-Link IE TSN Network synchronous communication function is shown.
■Communication speed setting status (RWr2.b8)
The setting status of the communication speed is shown.
Name Device number
Function selection status area RWr2
Function selection status area
RWr2 Input module Output module I/O combined module
b0 to b2 Input response setting status Use prohibited Input response setting status
b3 Use prohibited Output HOLD/CLEAR setting status Output HOLD/CLEAR setting status
b4, b5 CC-Link IE TSN Network synchronous
communication setting status
CC-Link IE TSN Network synchronous
communication setting status
CC-Link IE TSN Network synchronous
communication setting status
b6, b7 Use prohibited Use prohibited Use prohibited
b8 Communication speed setting status Communication speed setting status Communication speed setting status
b9 Use prohibited External power supply monitor status External power supply monitor status
b10 to b15 Use prohibited Use prohibited Use prohibited
Value in RWr2.b2 Value in RWr2.b1 Value in RWr2.b0 Setting status
Off Off Off 1ms
Off Off On 0ms
Off On Off 0.2ms
Off On On 1.5ms
On Off Off 5ms
On Off On 10ms
On On Off 20ms
On On On 70ms
Value for RWr2.b3 Setting status
Off CLEAR
On HOLD
Value in RWr2.b5 Value in RWr2.b4 Setting status
Off Off Asynchronous
Off On Synchronous (synchronous X/Y control mode)
On Off Synchronous (synchronization cycle timing control mode)
On On Synchronous (set time synchronization control mode)
Value for RWr2.b8 Setting status
Off 1Gbps
On 100Mbps
To Next Page
Loading...
