APPX
Appendix 2 Remote Register
241
A
ON/OFF selection flag
■Device number
■Description
This area is used for the set time synchronization control mode of the CC-Link IE TSN Network synchronous communication
function. ( Page 165 Set time synchronization control mode)
When the input time acquisition control is used, set which input change (rising edge or falling edge) is to be detected in this
area.
• Off (0): The I/O module detects the falling edge (ONOFF) of X.
• On (1): The I/O module detects the rising edge (OFFON) of X.
When the output time setting control is used, set which operation (turning off the output or turning on the output) is to be
performed at a preset time.
• Off (0): The output turns off at the time set in Output time setting Y (RWw10 to RWw8F).
• On (1): The output turns on at the time set in Output time setting Y (RWw10 to RWw8F).
Name Device number
ON/OFF selection flag RWw4, RWw5
ON/OFF selection flag
Device number I/O module (16-point module) I/O module (32-point module)
Input module Output module I/O combined
module
Input module Output module I/O combined
module
RWw4.b0X0Y0X0X0Y0X0
RWw4.b1X1Y1X1X1Y1X1
RWw4.b2X2Y2X2X2Y2X2
RWw4.b3X3Y3X3X3Y3X3
RWw4.b4X4Y4X4X4Y4X4
RWw4.b5X5Y5X5X5Y5X5
RWw4.b6X6Y6X6X6Y6X6
RWw4.b7X7Y7X7X7Y7X7
RWw4.b8X8Y8Y8X8Y8X8
RWw4.b9X9Y9Y9X9Y9X9
RWw4.b10 XA YA YA XA YA XA
RWw4.b11 XB YB YB XB YB XB
RWw4.b12 XC YC YC XC YC XC
RWw4.b13 XD YD YD XD YD XD
RWw4.b14 XE YE YE XE YE XE
RWw4.b15 XF YF YF XF YF XF
RWw5.b0 X10 Y10 Y10
RWw5.b1 X11 Y11 Y11
RWw5.b2 X12 Y12 Y12
RWw5.b3 X13 Y13 Y13
RWw5.b4 X14 Y14 Y14
RWw5.b5 X15 Y15 Y15
RWw5.b6 X16 Y16 Y16
RWw5.b7 X17 Y17 Y17
RWw5.b8 X18 Y18 Y18
RWw5.b9 X19 Y19 Y19
RWw5.b10 X1A Y1A Y1A
RWw5.b11 X1B Y1B Y1B
RWw5.b12 X1C Y1C Y1C
RWw5.b13 X1D Y1D Y1D
RWw5.b14 X1E Y1E Y1E
RWw5.b15 X1F Y1F Y1F
To Next Page
Loading...
