To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric PKFY-P and is the answer not in the manual?
General| Brand | Mitsubishi Electric |
|---|---|
| Model | PKFY-P |
| Category | Air Conditioner |
| Language | English |
Provides clearance requirements for installation and maintenance.
Lists accessories supplied with the indoor unit for installation.
Details on setting the fixture and drilling piping holes.
Determining unit position and piping hole locations using the mounting fixture.
Instructions for drilling the wall hole for piping.
Securing the wall mounting fixture considering unit weight and stability.
Guidance on embedding cooling pipes and drain pipes into the wall.
Steps for bending and preparing the piping for indoor unit connection.
Connecting the L-shaped pipe for right, left, and rear piping configurations.
Instructions for preparing the L-shaped pipe for lower piping installation.
Procedure for checking refrigerant pipe connections for leaks using nitrogen gas.
Wrapping refrigerant piping and drain hose with felt tape.
Arranging and wrapping drain hose and piping for rear, right, and lower configurations.
Connecting and wrapping drain hose and piping for left and left-rear configurations.
Steps for hanging and securing the indoor unit onto the mount board.
Mounting the unit with rear, right, or lower piping connections.
Mounting the unit with left or left-rear piping connections.
Instructions for wrapping and connecting refrigerant pipes with insulation.
Diagram showing piping and drain hose routing options for the indoor unit.
Detailed steps for flaring and connecting refrigerant pipes to the indoor unit.
Wrapping refrigerant piping within the unit's space using felt tape to prevent dripping.
Guidelines for drain pipe installation, inclination, and insulation to prevent condensation.
Steps for preparing and connecting the drain hose for left/left-rear piping.
Wrapping the drain hose and refrigerant piping with insulation.
Procedure to test drain functionality by filling the heat exchanger with water.
Instructions for connecting wires to the indoor unit's electrical parts.
Connecting electrical wires to the indoor unit's terminal boards.
Guidelines for power supply wiring, including cable types and protective devices.
Specifications for power cables, switches, and circuit breakers for the unit.
Details on compatible control and transmission cables for remote controllers.
Wiring diagrams for connecting remote controllers and transmission cables to indoor/outdoor units.
Connecting a MA remote controller to the indoor unit's TB15 terminal.
Connecting an M-NET remote controller to the indoor unit's TB5 terminal.
Connecting the wireless signal receiver to the indoor controller board.
Procedure for setting unit addresses and branch numbers using rotary switches.
Configuration for using the remote controller's built-in sensor for temperature sensing.
