Mitsubishi Electric Q06HCPU - Extension Base Units that can be Combined with the Main Base Unit

228
(6) Redundant power extension base unit (Q68RB)
No. Name Application
1) Extension cable connector
Connector for connecting an extension cable (for signal communications with the redundant
power main base unit or other extension base unit)
2) Base cover
Protective cover of extension cable connector.
Before connecting an extension cable, the part under OUT on the base cover must be
removed with a tool such as a flat blade screwdriver.
3) Base No. setting connector
Connector for setting the number of bases of redundant power extension base units.
( Page 78, Section 4.3.1)
4) Module connector
Connector for installing a redundant power supply module, I/O module and intelligent function
module.
To the connectors unused, attach the supplied connector cover or the blank cover module
(QG60) to prevent entry of dirt.
5) Module fixing screw hole Screw hole for fixing the module to the base unit. Screw size: M3 × 12
6) Base unit installation hole Hole for installing this base unit on a panel such as a control panel. (For M4 screw)
7) DIN rail adapter mounting hole DIN rail adapter mounting hole.
FG
SG
5V
5V
SG
FG
I/O0 I/O1 I/O2 I/O3 I/O4 I/O5 I/O6 I/O7
OUTIN
3)
5)
2)
1)
6)
4)
7)