252
• Clamp the Q8BAT connection cable.
Failure to do so may damage the Q8BAT connection cover, connector, or the cable due to unintentional swinging
and shifting or accidental pulling of the cable.
• Provide 10mm or more of the bending radius for the Q8BAT connection cable.
If the bending radius is less than 10mm, malfunction may occur due to characteristic deterioration and wire
breakage.
• For details of the module mounting position, refer to the following.
Page 60, Section 4.1.2
• Firmly push the connector all the way.
• When installing the Q8BAT for the Universal model QCPU, use the connection cable with “A” printed.
Mount the CPU module onto the main
base unit, so that the Q8BAT
connection cable connected to the
CPU module will not interfere with the
other devices.
Fix the Q8BAT onto the control panel.
(Screws or DIN rail is applicable.)
(From previous page)
Attach the connector of Q8BAT
connection cable to the Q8BAT while
confirming the orientation of the
connector.
Completed
Q8BAT
Control panel
Q8BAT
connection cable
Q8BAT
R (bending radius)
10mm or more
A
Sticke
To Next Page
Loading...
