EasyManua.ls Logo

Mitsubishi Electric Q12DCCPU-V - Functions

Mitsubishi Electric Q12DCCPU-V
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 - 1
4.1 Function List
4
FUNCTIONS
CHAPTER 4 FUNCTIONS
This chapter explains the C Controller module functions.
4.1 Function List
The following lists the C Controller module functions.
: Available, : Available but partially restricted,
: N/A
(To the next page)
Table 4.1 List of C Controller module functions
Function Description
Availability
Reference
section
Q12DC
CPU-V
Q06C
CPU-V
Q06C
CPU-V-B
I/O module access
function
Controls I/O modules or intelligent function modules from
the user program of the C Controller module.
Page 4-4,
Section 4.2
Intelligent function
module access function
Remote operation
function
Controls the execution status of the C Controller module
from its user program or development environment.
Page 4-5,
Section 4.3
Device function
Creates a device such as a programmable controller CPU in
work RAM of the C Controller module.
Page 4-18,
Section 4.4
Self-diagnostic function
Self-diagnostic
function
Monitors the operating status of each module, and when an
error has occurred, displays error information.
For the Q06CCPU-V(-B), the following cannot be detected.
•SRAM error
Built-in ROM error
Page 4-20,
Section 4.5
Hardware self-
diagnostic function
Perform the specified hardware self-diagnostics in the
hardware self-diagnostic mode.
For the Q06CCPU-V(-B), the following is not available.
USB diagnostic test
Bus diagnostic test
7-segment LED test
Page 16-75,
Section 16.5
Output (Y) setting for
switching from STOP to
RUN
Set the output status (Y) for the case where the STOP
status is switched to the RUN status.
Page 4-26,
Section 4.6
Clock function
Reads clock data in the C Controller module by the user
program, and uses them for time control.
Page 4-29,
Section 4.7
Multiple CPU clock
synchronization
function
Allows clock data synchronization with CPU No.1 when the
C Controller module is set as CPU No.2, No.3 or No.4 in a
multiple CPU system.
Page 4-33,
Section 4.7.1
Input response time
selection
Allows selection of the response time for the Q series input
modules, I/O combined modules, high-speed input
modules, and interrupt modules.
Page 4-34,
Section 4.8
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Q12DCCPU-V
Q06CCPU-V Q06CCPU-V-B

Table of Contents

Related product manuals