Mitsubishi Electric Q12DCCPU-V - Methods for Remote RUN;STOP

4 - 7
4.3 Remote Operation Function
4.3.1 Remote RUN/STOP
4
FUNCTIONS
(4) Methods for remote RUN/STOP
The remote RUN/STOP can be executed by either of the following two methods:
"Using user program" and "Using development environment (personal computer).
(a) Using user program
Execute a bus interface function (QBF_Control or QBF_ControlEx) from the user
program to perform remote RUN/STOP.
Remark
For the bus interface functions, refer to the following manual.
C Controller Module User's Manual (Utility Operation, Programming)
(b) Using development environment (personal computer)
In <<Online operation>> of C Controller setting utility, perform as described below.
1) Set "Remote operation" to "RUN" or "STOP" and select a C Controller module
or programmable controller CPU.
2) Click to execute remote RUN/STOP.
Figure 4.2 Remote RUN/STOP from development environment (personal computer)
Execute
2) Click
Execute button.
1) Set "RUN" or "STOP"
and select a target C
Controller module or
programmable
controller CPU.