Mitsubishi Electric Q12DCCPU-V - Changing Clock Data by a User Program; Reading Clock Data by a User Program

4
FUNCTIONS
4.7 Clock Function
4 - 32
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
(d) Changing clock data by a user program
When changing clock data by a user program, use the QBF_SetTime function.
If any other clock data setting function is used, correct clock data will not be set in
the C Controller module.
(e) Reading clock data by a user program
When reading clock data by the user program, functions other than QBF_GetTime
can be used.
Remark
For the bus interface functions, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)