Mitsubishi Electric Q12DCCPU-V - Error Time Output Mode Setting; What Is the Error Time Output Mode Setting?

4
FUNCTIONS
4.9 Error Time Output Mode Setting
4 - 36
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
4.9 Error Time Output Mode Setting
(1) What is the error time output mode setting?
This setting determines whether to clear or hold the outputs to the following Q series
modules when a stop error occurs in the C Controller module.
• Output modules
• I/O combined modules
• Intelligent function modules
• Interrupt modules
(2) Error time output mode setting
The error time output mode is set in "I/O assignment" in << I/O assignment settings>>
of C Controller setting utility.
1) Configure the I/O assignment settings.
2) Select .
3) Select "Clear" or "Hold" for each slot. (The default is "Clear".)
(3) Precautions
The error time output mode setting takes effect when:
• The C Controller system is powered on.
• The C Controller module is reset.
Figure 4.13 Error time output mode setting
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Detailed settings
1) Configure I/O assignment settings.
2) Click the Detailed settings button.
3) Select "Clear" or "Hold."