Mitsubishi Electric Q12DCCPU-V - Intelli. Module Side Start si No.

4 - 43
4.13 Interrupt from Intelligent Function Module
4
FUNCTIONS
4) Intelli. module side "Start SI No."
Set the intelligent function module interrupt pointer No. that was set at the
intelligent function module.
Setting range: 0 to 15
(b) Setting example
The following is a setting example, showing that SI 0 to 3 of an intelligent function
module mounted to the slot of start I/O No.20 are assigned to interrupt pointers 50
to 53.
Remark
This section explains the C Controller module side setting.
For the intelligent function module setting, refer to the following.
Manual for the intelligent function module
Figure 4.18 Interrupt event setting example