Mitsubishi Electric Q12DCCPU-V - Preparation for Use of the Telnet Function; Available Commands

4
FUNCTIONS
4.15 Telnet Function
4 - 48
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
4.15 Telnet Function
The Shell commands can be executed from the Telnet tool of the development
environment (personal computer) without using Workbench or Tornado.
This allows simple remote debugging (task information display, memory dumping, etc.) of
the C Controller module.
(1) Preparation for use of the Telnet function
A login name and password is required to use the Telnet function.
Set it for the C Controller module before using the Telnet function.
By setting the login user information (login name and password), Telnet users can be
restricted. ( Page 6-88, Section 6.11)
(2) Available commands
With the Telnet function, the commands that are executable in Workbench or Tornado
shells can be used.
Figure 4.23 Remote debugging using Telnet
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Development environment
(personal computer)
Remote control
by Telnet!
Telnet
C Controller module