A - 13
(2) Precautions for standard RAM, standard ROM, and CompactFlash card
: Available, : N/A
(a) Standard RAM formatting
1) When formatting the standard RAM
Be sure to perform the method described in the following section.
Page 6-77, Section 6.10.1 (6)
Do not format it by using a command from Workbench Shell.
2) During standard RAM formatting
Do not power off or reset the C Controller module during standard RAM
formatting.
Doing so causes the standard RAM to be formatted again when the C
Controller module is started the next time.
(b) Standard ROM formatting
1) When formatting the standard ROM
Be sure to perform the method described in the following section.
Page 6-85, Section 6.10.2 (4)
Do not format it by using a command from Tornado Shell.
2) During standard ROM formatting
Do not power off or reset the C Controller module during standard ROM
formatting.
Doing so causes the standard ROM to be formatted again when the C
Controller module is started the next time.
(c) Allowable number of writes to the standard ROM (service life)
A flash ROM is used for the standard ROM and it has a limit in the number of
writes (service life). ( Page 6-71, Section 6.9)
Table A.1 Memory availability
Memory
Availability
Q12DCCPU-V Q06CCPU-V Q06CCPU-V-B
Standard RAM
Standard ROM
CompactFlash card
To Next Page
Loading...
