6 - 32
6.4 Part Names and Functions
6.4.2 Part names and functions of the Q06CCPU-V(-B)
6
PREPARATORY PROCEDURES AND SETTING
* 1 Keep the dummy CompactFlash card in a safe place after replacing it so that it can be used again.
* 2 Operate the RUN/STOP/MODE and RESET/SELECT switches by hand.
Using a tool such as a screwdriver can cause a failure.
Table 6.11 Part names
Name Description
1) Indicator LEDs
For the indicator LEDs, refer to the following.
(1) in this section
2)
10BASE-T/100BASE-TX interface
connector (RJ45)
Used to connect a C Controller module to 10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T or 100BASE-TX depending on
the target device.)
3) RS-232 interface connector Used to connect a C Controller module to an RS-232 cable.
4) Serial number plate Indicates the serial number of the C Controller module.
5)
RUN/STOP/MODE switch
*2
For the RUN/STOP/MODE switch, refer to the following.
(2) in this section
6)
RESET/SELECT switch
*2
For the RESET/SELECT switch, refer to the following.
(3) in this section
7) EJECT button (Q06CCPU-V only) Used to eject a CompactFlash card from a C Controller module.
8)
CompactFlash card slot
(Q06CCPU-V only)
Slot into which a CompactFlash card is installed.
(A dummy CompactFlash card is factory-installed.
*1
)
9) Battery
Used to back up data in the standard ROM, data in the battery-backed-up RAM,
and clock data.
10) Battery connector pin
Used to connect a battery lead wire.
(The lead wire is disconnected from the connector before shipping to prevent
battery drain.)
To Next Page
Loading...
