Mitsubishi Electric Q12DCCPU-V - Changing the IP Address of the C Controller Module; Displaying the Relevant Tab; Setting an IP Address

6
PREPARATORY PROCEDURES AND SETTING
6.6 Network Settings for 1:1 Connection
6 - 43
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
(5) Changing the IP address of the C Controller module
To change the default IP address of the C Controller module, perform the operations
described below.
• Default IP address of CH1: 192.168.3.3
• Default IP address of CH2: No setting (Q12DCCPU-V only)
(a) Displaying the relevant tab
In the <<Online operation>> tab of C Controller setting utility, click the
button and select the <<IP address>> tab.
(b) Setting an IP address
Change the preset IP address (and Subnet mask and/or Default gateway as
necessary) and click the button.
After changing the data, reset the C Controller module to update the IP address
settings.
Figure 6.38 <<Online operation>> tab
Figure 6.39 IP address setting
Detail
Set