6 - 44
6.6 Network Settings for 1:1 Connection
6
PREPARATORY PROCEDURES AND SETTING
(c) Network settings for the development environment (personal computer)
Change the network settings (IP address) of the development environment
(personal computer) as needed, and shutdown the personal computer.
(d) Connection to LAN
Disconnect the Ethernet cable from the C Controller module and development
environment (personal computer).
Then, connect the C Controller module and development environment (personal
computer) separately to LAN with different Ethernet cables (straight cables).
(e) Access to the C Controller module
Restart the C Controller module and development environment (personal
computer), and perform the operations described in (3) in this section.
(f) Confirmation of monitoring
Access the C Controller module from C Controller utility on the development
environment (personal computer), and check that each status of the module can
be monitored.
To Next Page
Loading...
