Mitsubishi Electric Q12DCCPU-V - Removing or Replacing the Compactflash Card

6
PREPARATORY PROCEDURES AND SETTING
6.8 Inserting/Removing a CompactFlash Card and Access Stop
6.8.1 Inserting/removing the CompactFlash card
6 - 61
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
Insert or remove a CompactFlash card according to the following procedure.
Especially, when removing or replacing the CompactFlash card, stop accessing to the
CompactFlash card.
Figure 6.47 Removing or replacing the CompactFlash card
No
No
No
No
Yes
Yes
Yes
Yes
Removal or replacement of
CompactFlash card
Insert a CompactFlash card
Has the C Controller system
been powered off?
Remove the CompactFlash card.
( )
Replace the CompactFlash
card?
Insert a new CompactFlash card.
( )
End
File writing to the CompactFlash
card is stopped?
Unmount the CompactFlash card
without user program?
Unmount the CompactFlash card by the
RESET/SELECT switch.
( )
Stop access to the CompactFlash card.
( )
Insert a dummy CompactFlash card.
Page 6-67, Section 6.8.3
Page 6-64, Section 6.8.2
(2) in this section
(1) in this section