Mitsubishi Electric Q12DCCPU-V - Base Mode Setting in C Controller Setting Utility; I;O Assignment Settings

7
I/O NUMBER ASSIGNMENT
7.3 Base Unit Assignment (Base Mode)
7 - 12
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
(3) Base mode setting in C Controller setting utility
(a) Base model
Enter the base unit model name within 16 characters.
The C Controller module does not recognize this setting. (Use this setting as a
note.)
(b) Power model
Enter the power supply module name within 16 characters.
The C Controller module does not recognize this setting. (Use this setting as a
note.)
(c) Extension cable
Enter the extension cable model name within 16 characters.
The C Controller module does not recognize this setting. (Use this setting as a
note.)
(d) Slots (C Controller module uses this setting.)
Select one of the following options for the base unit.
• 2 (2 slots)
• 3 (3 slots)
• 5 (5 slots)
• 8 (8 slots)
• 10 (10 slots)
• 12 (12 slots)
(e) 8 slot default/12 slot default (C Controller module uses this setting.)
Select either option to set the same number of slots for all base units.
(f) Auto/Detail
Select the Auto or Detail mode for base unit assignment.
Figure 7.12 I/O assignment settings
(a) (b) (c) (d)
(e)
(f)