Mitsubishi Electric Q12DCCPU-V - Data Storable in User Memories of the C Controller Module

8 - 3
8.1 Memories of the C Controller Module
8.1.1 User memories
8
MEMORIES AND FILES
(1) Data storable in user memories of the C Controller module
The following table lists the data storable in user memories of the C Controller
module.
: Storable, : Not storable
* 1 For the following C Controller modules, store the C Controller setting parameters and network
parameters in the same drive, either the standard RAM or CompactFlash card.
• Q12DCCPU-V with a serial number whose first five digits are "12042" or later.
If parameters are stored in different drives, the parameters in the drive where the C Controller
setting parameters are stored are valid.
When C Controller setting parameters are stored in both standard ROM and CompactFlash card,
the parameters in the CompactFlash card will be valid.
* 2 For the following C Controller modules, parameters cannot be stored in a CompactFlash card.
• Q12DCCPU-V with a serial number whose first five digits are "12041" or higher.
• Q06CCPU-V(-B)
* 3 Store script files in any of the standard RAM, the standard ROM, and a CompactFlash card.
* 4 The stored user program is read out to the work RAM for execution.
* 5 The file read from the user program can be stored.
For writing from the user program, use files in the CompactFlash card. ( Page 6-71, Section
6.9)
* 6 A RAM disk must be created by the user program.
Remark
For script files and sample programs, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
Table 8.2 Data that can be stored in user memories
Data
Built in the C Controller module
CompactFlash
card
Standard
RAM
Standard
ROM
Work RAM
Battery-backed-
up RAM
Parameter (C Controller setting
parameter, network parameter)
*1
*1*2
Script file
*3 *3 *3
User program
*4 *4 *6 *4
Data used in the user program (file)
*5 *6
Data used in the user program (other
than file)