Mitsubishi Electric Q12DCCPU-V - Parameters Required for the Multiple CPU System

15
STARTING A MULTIPLE CPU SYSTEM
15.2 Setting Parameters Added for Multiple CPU Systems
15.2.2 Parameters required for the multiple CPU system
15 - 5
9
DEVICE DESCRIPTION
10
MULTIPLE CPU SYSTEM OVERVIEW
11
MULTIPLE CPU SYSTEM CONFIGURATION
12
CONCEPT OF MULTIPLE CPU SYSTEM
13
COMMUNICATIONS BETWEEN CPU MODULES
14
PARAMETERS ADDED FOR MULTIPLE CPU SYSTEMS
15
STARTING A MULTIPLE CPU SYSTEM
16
TROUBLESHOOTING
15.2.2 Parameters required for the multiple CPU system
The following parameters are required for the multiple CPU system.
The same parameters must be set to the items marked as "Same setting to all CPU
modules" for all CPU modules in the multiple CPU system unless otherwise noted.
( Page 14-1, Section 14.1)
(1) For the Q12DCCPU-V
Figure 15.3 List of parameters required for the multiple CPU system
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Multiple CPU settings
Operation mode
I/O sharing when using Multiple CPUs
Send range for each CPU
I/O assignment settings
I/O assignment
Base setting
Slots
System settings
Points occupied by empty slot
Setting required
Same setting to all CPU modules
Number of CPUs
Detailed settings: Control CPU
Advanced settings
Use multiple CPU high
speed transmission
CPU specific send range
Auto refresh settings Points
System area
Multiple CPU high speed transmission
area setting
Multiple CPU synchronous startup setting
Communication area setting
(refresh setting)