Mitsubishi Electric Q12DCCPU-V - When a File (Program) Cannot be Written

16 - 15
16.2 Troubleshooting
16.2.8 When a file (program) cannot be written
16
TROUBLESHOOTING
16.2.8 When a file (program) cannot be written
The following flowchart shows the procedures to be taken when a file such as a user
program file cannot be written to the C Controller module.
* 1 Standard RAM, standard ROM or CompactFlash card
Figure 16.7 When a program cannot be written
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
No
Yes
No
Yes
Unable to write a file such
as a user program file.
Is there free space in
the memory
*1
?
Is the MODE LED
on the C Controller
module lit?
Yes
Consult your local Mitsubishi
service center or representative,
explaining the details of the
problem.
1)
2)
Off ( )
Flashing
Restart the C Controller system to turn
on the MODE LED.
Check <<Module information>> of C
Controller setting utility for free memory
*1
space. Make free space if sufficient
space is not available.
No
Is there another
user program using
the file?
Terminate the user program that is using
the file, and write the file again.
Page 16-5, Section 16.2.2