APPX - 22
Appendix 8 Parameter Number List
APPENDICES
Appendix 8 Parameter Number List
A parameter number is displayed on the Detailed event information screen of C Controller
setting utility when an error occurs in parameter setting. ( Page 16-34, Section 16.3)
This section provides the tables indicating parameter numbers and where each parameter
is to be set.
(1) Symbols, mn, **, M, and N used in the "Parameter No." column
mn, **, M, and N in the "Parameter No." column denote the following:
mn: Start I/O No. divided by 16
**: Any given value
N: The module number
M: Network type
Table APPX.22 In CC-Link IE controller network setting
M Network type
1H Control station
2H Normal station
Table APPX.23 In MELSECNET/H setting
M Network type
1H
MELSECNET/10 mode (Control station),
MELSECNET/H mode (Control station),
MELSECNET/H Extended mode (Control station)
2H
MELSECNET/10 mode (Normal station),
MELSECNET/H mode (Normal station),
MELSECNET/H Extended mode (Normal station)
5H MELSECNET/H (Remote master station)
AH MELSECNET/H (Standby station)
BH MELSECNET/H mode multiplexed remote I/O network master station
DH
MELSECNET/H mode multiplexed remote I/O network sub-master station
(When there is no parameter setting)
EH
MELSECNET/H mode multiplexed remote I/O network sub-master station
(When there is parameter setting)
Table APPX.24 In CC-Link setting
M Network type
0H Master station
1H Local station
2H Standby master station
To Next Page
Loading...
