Mitsubishi Electric Q12DCCPU-V - Operation Processing; Initial Processing

3 - 6
3.4 Operation Processing
3.4.1 Initial processing
3
SPECIFICATIONS
3.4 Operation Processing
3.4.1 Initial processing
The initial processing is preprocessing executed upon startup of the C Controller module.
When the initial processing is completed, the C Controller module is placed in the status
preset by the RUN/STOP/MODE switch.
The following lists the initial processing details performed when the C Controller module is
powered on or reset.
Table 3.5 Initial processing list
Initial processing
C Controller module status
When powered on When reset
I/O module initialization
Parameter check
Automatic assignment of mounted module I/O
numbers
IP address setting of C Controller module
CC-Link information setting
MELSECNET/H information setting
CC-Link IE controller network information setting
Intelligent function module switch setting
Intelligent function module initial value setting
Script file execution
(e.g. starting a user program from the standard RAM,
standard ROM, or a CompactFlash card)
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B