6 - 21
6 INSPECTION AND MAINTENANCE
(c) Flowchart for when the 7-segment LED stops with an
initializing item (b00 to o99)
The following shows the flowchart for when the 7-segment LED stops with
an initializing item (b00 to o99).
1)
END
YES
NO
Wait approximately 1 minute with the
initializing item displayed (b00 to o99)
The 7-segment LED stopped with an
initializing item (b00 to o99)
NO
NO
NO
YES
YES
YES
Did the
7-segment LED display
change from the initializing
item (b00 to o99)?
7-Did the
7-segment LED display
"STOP" or "RUN"?
Did the
7-segment LED display
"AL" "L01"?
Did the
7-segment LED display
"AL" "A1" " "?
Set the Motion controller
rotary switch 2 (SW2) to "C", and
clear the SRAM.
Set the Motion controller
rotary switch 1 (SW1) to "0", and
rotary switch 2 (SW2) to "0".
(g)
Flowchart for when "AL" "A1"
" "displays on 7-segment LED
(f)
Flowchart for when "AL" "L01"
displays on 7-segment LED
To Next Page
Loading...
