Mitsubishi Electric Q170MSCPU - APPENDIX 1.3 Differences between CPU Display and I;O Assignment

APP - 4
APPENDICES
APPENDIX 1.3 Differences between CPU display and I/O assignment
Table 1.3 Differences between CPU display and I/O assignment
Item Q170MSCPU Q173DSCPU/Q172DSCPU
CPU display
• Motion CPU area : Q170MSCPU-PCPU
• PLC CPU area : Q03UDCPU (Q170MSCPU use)
Q06UDHCPU (Q170MSCPU-S1
use)
• Motion CPU : Q173DSCPU, Q172DSCPU
• PLC CPU : Q06UDHCPU, etc.
I/O assignment
setting
Base mode
(Auto)
• The main base of eight slots corresponding is built
into the Q170MSCPU.
• 16 points are set to each empty slot.
• First address of the extension base is "70".
• The main base and extension base are
automatically determined.
• I/O or empty slot, etc. is automatic determined,
and the points are assigned.
Base mode
(Detail)
• I/O assignment points are individually assigned.
When the first address of the extension base is set
to address "0", the setting is as follows.
• Main base: 8 slots
• Number of points of each empty slot: 0 point
• I/O assignment points are individually assigned.
The CPU display and setting of I/O assignment are shown below.
(1) CPU display
Confirm the CPU display of the PLC CPU area and Motion CPU area on the
System Monitor screen displayed on [Diagnostics] – [System monitor] of
GX Works2.
PLC CPU area is displayed as " Q03UDCPU (Q170MSCPU use)/Q06UDHCPU
(Q170MSCPU-S1 use)", and Motion CPU area is displayed as "Q170MSCPU-
PCPU".
PLC CPU area
(Q03UDCPU/
Q06UDHCPU)
Motion CPU area
(Q170MSCPU-PCPU)