Mitsubishi Electric Q173DSCPU - Page 100

1 - 77
1 OVERVIEW
14) Table of the common devices (SV13/SV22)
Device No. Signal name
Signal
direction
Device No. Signal name
Signal
direction
D704 PLC ready flag request
Command
device
D740 Axis 21
Manual pulse generators 1 pulse
input magnification setting register
(Note-2, 3)
Command
device
D705
Speed switching point specified flag
request
D741 Axis 22
D706 All axes servo ON command request D742 Axis 23
D707
Real mode/virtual mode switching
request (SV22)
(Note-1)
D743 Axis 24
D708
JOG operation simultaneous start
command request
D744 Axis 25
D709 Unusable — D745 Axis 26
D710
JOG operation simultaneous start
axis setting register
Command
device
D746 Axis 27
to D747 Axis 28
D713 D748 Axis 29
D714
D715
Manual pulse generator axis 1 No.
setting register
D749 Axis 30
D750 Axis 31
D751 Axis 32
D716
D717
Manual pulse generator axis 2 No.
setting register
D752
Manual pulse generator 1 smoothing
magnification setting register
D753
Manual pulse generator 2 smoothing
magnification setting register
D718
D719
Manual pulse generator axis 3 No.
setting register
D754
Manual pulse generator 3 smoothing
magnification setting register
D720 Axis 1
Manual pulse generators
1 pulse input magnification
setting register
(Note-2, 3)
D755 Manual pulse generator 1 enable flag request
D721 Axis 2 D756 Manual pulse generator 2 enable flag request
D722 Axis 3 D757 Manual pulse generator 3 enable flag request
D723 Axis 4 D758
Unusable
(42 points)
—
D724 Axis 5
to
D725 Axis 6
D726 Axis 7
D727 Axis 8
D728 Axis 9
D729 Axis 10
D730 Axis 11
D731 Axis 12
D732 Axis 13
D733 Axis 14
D734 Axis 15
D735 Axis 16
D736 Axis 17
D737 Axis 18
D738 Axis 19
D739 Axis 20 D799
(Note-1): It is unusable in the SV22 advanced synchronous control.
(Note-2): The following range is valid.
Q172DSCPU: Axis No.1 to 16, Q172DCPU(-S1): Axis No.1 to 8
(Note-3): The following device area is unusable.
Q172DSCPU: 17 axes or more, Q172DCPU(-S1): 9 axes or more