Mitsubishi Electric Q173DSCPU - Same Data Block Transfer: FMOV

5 - 104
5 OPERATION CONTROL PROGRAMS
F/FS G
5.13.5 Same data block transfer : FMOV
Format FMOV(D), (S), (n) Number of basic steps 6
[Usable data]
Setting
data
Usable Data
Bit device
Word device Constant
Calculation
expression
Bit
conditional
expression
Comparison
conditional
expression
16-bit
integer
type
32-bit
integer
type (L)
64-bit
floating
point
type (F)
Coasting
timer
16-bit
integer
type (K/H)
32-bit
integer type
(K/H, L)
64-bit
floating
point
type (K)
(D)
— — — — — — — —
(S)
— — — — — — — —
(n) —
— — — — — — — —
: Usable
[Setting data]
Setting data Description Data type of result
(D) Transfer destination device starting No.
— (S)
Device No. which transfer data or data to be
transferred are stored.
(n) Number of words to be transferred
[Functions]
(1) The data specified with (S) or contents of device are transferred a part for
(n)words of data to the device specified with (D).
(2) The devices that may be set at (D), (S) and (n) are shown below.
Setting
data
Word devices
(Note-1)
Bit devices
(Note-1), (Note-2)
Dn Wn SDn U \Gn #n
Mn U
\Gn.m Bn Fn SMn Xn Yn
(D)
— — —
(Note-3) (Note-3)
(S)
—
(Note-3) (Note-3)
(n)
— — — — — — — —
(Note-1) : The device No. cannot be specified indirectly.
(Note-2) : Specify a multiple of 16 as the device number of bit data.
(Note-3) : PX/PY cannot be set.
[Errors]
(1) An operation error will occur if:
• (D) to (D)+(n-1) is outside the device range
• (n) is 0 or a negative number
• PX/PY is set in (D) to (D)+(n-1)
When (n) specified is a
word device