5 - 117
5 OPERATION CONTROL PROGRAMS
[Functions]
(1) (n) words of data from the device specified with (S) are written to the address
specified with (D3) and after of the buffer memory in the intelligent function
module specified with (D2).
The intelligent function module is mounted to the target SSCNET
/H head
module specified with (D1).
After writing completion of the device data, the complete bit device specified with
(D4) turns ON.
H0000
H0005
H000A
H0000
(S)
H0000
H0005
H000A
H0000
(D3)
(D2)
(D1)
Device memory
Write the data
of a part for
(n)words
Intelligent
function module
buffer memory
SSCNET /H head module
(2) First I/O No. of the module mounted to the SSCNET
/H head module set by
system setting is specified by (D2).
MR-J4(W)- B
Q173DS
CPU
Q03UD
CPU
Power
supply
module
QX40
First
I/O No.
No.: 00H
Q64AD
First
I/O No.
No.: 10H
Q64DAN
First
I/O No.
No.: 20H
MR-J4(W)- B
Power
supply
module
LX40C6
First
I/O No.
No.: 30H
L60AD4
First
I/O No.
No.: 40H
L60DA4
First
I/O No.
No.: 50H
SSCNET /H
head
module
(D2) sets 05H by the system setting when a RTO instruction is executed in the
D/A conversion module (L60DA4).
(3) The word devices that may be set at (D1), (D2), (D3), (S), (n), and (D4) are shown
below.
Setting data
Word devices
(Note-1)
Bit devices
(Note-1), (Note-2)
Dn Wn SDn U \Gn #n
Mn U
\Gn.m Bn Fn SMn Xn Yn
(D1)
—
— — — — — — —
(D2)
—
— — — — — — —
(D3)
—
— — — — — — —
(S)
—
—
—
(Note-3)
(Note-3)
(n)
—
— — — — — — —
(D4) — — — — —
—
(Note-1): The device No. cannot be specified indirectly.
(Note-2): Specify a multiple of 16 as the device number of bit data.
(Note-3): PX and PY cannot be set.
To Next Page
Loading...
