5 - 128
5 OPERATION CONTROL PROGRAMS
[Errors]
(1) An operation error will occur if:
• The (S1) data is outside the range of 1 to 8.
• The (S2) data is outside the range of 1 to 32767.
• MVOPEN is executed again for the vision system that has been logged on.
• The vision system parameter setting (Refer to APPENDIX 3.2.) is different from
the setting on the vision system.
• The logon is not completed when the specified timeout time has elapsed.
[Program examples]
(1) Program which logs on the vision system of the vision system (camera) 3
MVOPEN K3
To Next Page
Loading...
