5 - 140
5 OPERATION CONTROL PROGRAMS
F/FS G
5.15.7 Reset a status storage device : MVFIN
Format MVFIN(S) Number of basic steps 2
[Usable data]
Setting
data
Usable Data
Bit device
Word device
(Note-1)
Constant
Calculation
expression
Bit
conditional
expression
Comparison
conditional
expression
16-bit
integer
type
32-bit
integer
type (L)
64-bit
floating
point
type (F)
Coasting
timer
16-bit
integer
type (K/H)
32-bit
integer type
(K/H, L)
64-bit
floating
point
type (K)
(S) —
— — —
— — — — —
: Usable
(Note-1): The special register (SD) cannot be used.
[Setting data]
Setting data Description Data type of result
(S)
Vision system (camera) No. to reset the status
storage device (1 to 8)
—
[Functions]
(1) The status storage device value set in the Ethernet communication line setting
parameter specified with (S) is 20 (reception enabled). (Refer to APPENDIX 3.2.)
(2) When a trigger is issued to the vision system, the status storage device is reset by
MVFIN instruction in advance, and the process completion for trigger needs to be
detected.
[Errors]
(1) An operation error will occur if:
• The (S) data is outside the range of 1 to 8.
• The vision system specified with (S) has not been logged on.
• The vision system parameter setting (Refer to APPENDIX 3.2.) is different from
the setting on the vision system.
• The status storage device value set in the Ethernet communication line setting
parameter is not 20 (reception enabled), 40 (Image data reception completed),
or 50 (value cell reception completed).
[Program examples]
(1) Program which resets the status storage device for the vision system (camera) 1
MVFIN K1
To Next Page
Loading...
