196
7.2 Specifications
7.2.1 Power supply module specifications
The following table lists specifications of power supply modules.
Item
Performance Specifications
Q61P-A1 Q61P-A2 Q61P Q62P
Mounting position Power supply module mounting slot
Applicable base unit Q3B, Q3DB, Q6B
Input power supply
100 to 120VAC
(85 to 132VAC)
200 to 240VAC
(170 to 264VAC)
100 to 240VAC
(85 to 264VAC)
Input frequency 50/60Hz ±5%
Input voltage distortion
factor
Within 5% ( Page 103, Section 4.8.1)
Max. input apparent
power
105VA 120VA 105VA
Max. input power ----
Inrush current
*1
20A within 8ms
Rated output
current
5VDC 6A 3A
24VDC ---- 0.6A
External output voltage ---- 24VDC ±10%
Overcurrent
protection
*1
5VDC 6.6A or more 3.3A or more
24VDC ---- 0.66A or more
Overvoltage
protection
*1
5VDC 5.5 to 6.5V
24VDC ----
Efficiency 70% or more 65% or more
Allowable momentary
power failure time
*1
Within 20ms
Dielectric withstand
voltage
2300VAC per minute (altitude 0 to 2000m)
Between the combined "line input/LG terminals" and the "FG terminal and output"
Insulation resistance
10MΩ or higher by 500VDC insulation resistance tester
Between the combined "line input/LG terminals" and the "FG terminal and output", the line input and
LG terminals, the output and FG terminals
Noise durability
• By noise simulator of 1500Vp-p noise voltage, 1µs noise width and 25 to 60Hz noise frequency
• Noise voltage IEC 61000-4-4, 2KV
Operation indication LED indication (Normal: On (green), Error: Off)
Fuse Built-in (User-unchangeable)
+10%
-15%
To Next Page
Loading...
