Mitsubishi Electric Q26UD(E)HCPU - CHAPTER 3 CPU MODULE START-UP PROCEDURES

55
CHAPTER 2 SYSTEM CONFIGURATION
2
2.3 Precautions for System Configuration 2.3.2 Peripheral device configuration
(b) QnUDVCPU
*1 For the writing method to an SD memory card, refer to the following.
GX Works2 Version 1 Operating Manual (Common)
*2 For USB cables, refer to the following.
GX Works2 Version 1 Operating Manual (Common)
*3 For the GX Works2 versions that can be used with the Universal model QCPU, refer to Page 634, Appendix 5.1.
*4 Use the following Ethernet cables.
• For 10BASE-T connection: Cables compliant to Ethernet standards, category 3 or higher (STP/UTP cables (In an
environment subject to electric noise, use shielded twisted pair (STP) cables.))
• For 100BASE-TX connection: Cables compliant to Ethernet standards, category 5 or higher (STP cables)
1
SD memory card
Universal model QCPU
USB cable
(Connector type miniB)
2
Ethernet cable
4
Personal Computer
(GX Works2)
3
Extended SRAM cassette