5 - 24 5 - 24
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
(5) Fine adjustment of voltage output or current output
By clicking the + button or - button, the value of voltage output or current
output for the prepared adjustment value is finely adjusted.
(6) Write settings into module
Write the content set up by operations (2) to (5) into module by clicking the
Registration
button.
(a) Precautions
Avoid the following operations during the writing of the data, which has
been set up by operations (2) to (5), into the module after the click of the
Registration
button. Doing so causes an error in the E
2
PROM data and
the D/A converter module may not operate properly.
1) Power off the programmable controller CPU.
2) Reset the programmable controller CPU.
(7) Switch to the normal mode
When the offset/gain setting dialog box is closed by clicking the Close button
after the setting operation has finished, module's operation mode transits to the
normal mode.
POINT
If Error code is displayed while performing the setting operation, the details and
measure of the error can be confirmed by clicking the ...
button to the right of the
error code display area. In addition, Error code can be cleared by clicking the
Error clear
button.
To Next Page
Loading...
