Mitsubishi Electric Q62DAN - Page 103

5 - 26 5 - 26
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
(3) Specify a channel
Specify the target channel of offset setting or gain setting on the channel No.
combo box.
(4) Specify offset/gain setting
Specify either offset setting or gain setting on the channel specified on the
channel No. combo box using the radio button.
(5) Set up adjustment values
Set up an adjustment value of the offset value or gain value. Select "1", "10,"
"100", or "1000" on the combo box, however, you can also set up adjustment
values by entering a number (1 to 3000).
(6) Fine adjustment of voltage output or current output
By clicking the + button or - button, the value of voltage output or current
output for the prepared adjustment value is finely adjusted.
(7) Write settings into module
Write the content set up by operations (3) to (6) into module by clicking the
Registration
button.
(a) Precautions
Avoid the following operations during the writing of the data, which has
been set up by operations (3) to (6), into the module after the click of the
Registration
button. Doing so causes an error in the E
2
PROM data and
the D/A converter module may not operate properly.
1) Power off the programmable controller CPU.
2) Reset the programmable controller CPU.
(8) Switch to the normal mode
After the setting is finished, click the Close button to close the offset/gain
setting dialog box, and set Switch 4 of the intelligent function module switch
settings to the normal mode. (Refer to Section 4.5.)
POINT
If Error code is displayed while performing the setting operation, the details and
measure of the error can be confirmed by clicking the ...
button to the right of the
error code display area. In addition, Error code can be cleared by clicking the
Error clear
button.