Mitsubishi Electric Q62DAN - (2) Operating the utility package

6 - 8
6 - 8
MELSEC-Q
6 PROGRAMMING
(2) Operating the utility package
(a) Initial setting (Refer to Section 5.4)
CH1, CH2 D/A conversion enable/disable setting .... "Enable"
(b) Auto refresh setting (Refer to Section 5.5)
CH1, CH2 digital value ............................................... W11, W12
Error code ................................................................... W113
(c) Write of intelligent function module parameters (Refer to Section 5.3.3)
The intelligent function module parameters are written to the remote I/O
station.
Perform this operation on the parameter setting module selection screen.