2 - 2
2 - 2
MELSEC-Q
2 SYSTEM CONFIGURATION
(4) Supported software packages
The relationship between the system including the D/A converter module and the
software package is shown in the following table.
GX Developer or GX Works2 is necessary when using the D/A converter module.
Software Version
GX Developer
GX Configurator-DA
1, 2
GX Works2
Q00J/Q00/Q01CPU
Single CPU system Version 7 or later
Version 1.10L or later
(cannot be used with the
SW0D5C-QDAU-E 60G
or earlier versions).
Refer to the GX Works2
Version 1 Operating
Manual (Common).
Multiple CPU system Version 8 or later
Q02/Q02H/Q06H/
Q12H/Q25HCPU
Single CPU system Version 4 or later
SW0D5C-QDAU-E 00A
or later
Multiple CPU system Version 6 or later
SW0D5C-QDAU-E 20C
or later
Q02PH/Q06PHCPU
Single CPU system
Version 8.68W or
later
Version 1.13P or later
(cannot be used with the
SW0D5C-QDAU-E 60G
or earlier versions).
Multiple CPU system
Q12PH/Q25PHCPU
Single CPU system
Version 7.10L
or later
Multiple CPU system
Q12PRH/
Q25PRHCPU
Redundant CPU
system
Version 8.45X or
later
Version 1.15R or later
Q00UJ/Q00U
Q01UCPU
Single CPU system
Version 8.78G or
later
Version 2.06G or later
Multiple CPU system
Q02U/Q03UD/
Q04UDH/
Q06UDHCPU
Single CPU system
Version 8.48A or
later
Multiple CPU system
Q10UDH/
Q20UDHCPU
Single CPU system
Version 8.78G or
later
Multiple CPU system
Q13UDH/
Q26UDHCPU
Single CPU system
Version 8.62Q
or later
Multiple CPU system
Q03UDE/Q04UDEH/
Q06UDEH/Q13UDEH/
Q26UDEHCPU
Single CPU system
Version 8.68W
or later
Multiple CPU system
Q10UDH/
Q20UDHCPU
Single CPU system
Version 8.78G or
later
Multiple CPU system
CPU modules other
than the above
Single CPU system
Not supported Not supported
Multiple CPU system
If installed in a MELSECNET/H remote I/O
station
Version 6 or later
SW0D5C-QDAU-E 50F
or later
2
To Next Page
Loading...
