Mitsubishi Electric Q62DAN - Page 77

4 - 17
4 - 17
MELSEC-Q
4 SETUP AND PROCEDURES BEFORE OPERATION
(b) When switching the mode to the setting of Mode switching setting (buffer
memory address 158, 159: Un\G158, Un\G159) and Operating condition
setting request (Y9).
POINT
When running this program together with the normal-mode A/D conversion
program (shown in Section 6.4.2), use 1 of this program as the initial setting
program.
Note) When adding this program to the normal-mode D/A conversion program
(shown in Section 6.4.2), replace the existing initial setting items with the
program marked 1.
(c) When switching the mode by making intelligent function module switch
setting
Only the common program is necessary.