5 - 1 5 - 1
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
5 UTILITY PACKAGE (GX Configurator-DA)
5.1 Utility Package Functions
Table 5.1 shows an overview of the utility package functions.
Table 5.1 Utility package (GX Configurator-DA) function list
Item Description Reference section
Initial Setting
1
(1) Sets D/A conversion enable/disable.
(2) The data for which initial setting has been completed is registered in
the parameters for the programmable controller CPU, and
automatically written to the D/A converter module when the
programmable controller CPU changes to RUN status.
Section 5.4
Auto Refresh Setting
1
(1) Sets automatic refresh for the D/A converter module buffer memory.
(2) The buffer memory that was set for automatic refresh is
automatically read and written to the specified device when the
END command for the programmable controller CPU is executed.
Section 5.5
Monitor/test
(1) Monitor/test
The buffer memory and I/O signals for the D/A converter modules
are monitored and tested.
(2) Operating condition setting
Changes D/A conversion enable/disable during the operation.
(3) Offset/gain setting
When setting the offset/gain to a value selected by the user (when
the analog output range setting is user range setting), the offset and
gain can be easily set while viewing the dialog box.
(4) Pass data
The pass data (Pass data classification setting, industrial shipment
settings offset/gain values, user range settings offset/gain values)
can be monitored and set.
Section 5.6
FB conversion
Generates FB automatically from the intelligent function module
parameter (initial setting/auto refresh setting).
Section 5.7
POINT
1 If initial setting and auto refresh setting are performed, the intelligent function
module parameters require a maximum of 24 bytes per module.
5
To Next Page
Loading...
