5 - 3 5 - 3
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
(6) Number of parameters that can be set in GX Configurator-DA
When multiple intelligent function modules are mounted, the number of
parameter setting must not exceed the following limit.
When intelligent function modules are installed to:
Maximum number of parameter settings
Initial setting Auto refresh setting
Q00J/Q00/Q01CPU 512 256
Q02/Q02H/Q06H/Q12H/Q25HCPU 512 256
Q02PH/Q06PH/Q12PH/Q25PHCPU 512 256
Q12PRH/Q25PRHCPU 512 256
Q00UJ/Q00U/Q01UCPU 512 256
Q02UCPU 2048 1024
Q03UD/Q04UDH/Q06UDH/Q10UDH/
Q13UDH/Q20UDH/Q26UDH/Q03UDE/
Q04UDEH/Q06UDEH/Q10UDEH/Q13UDEH/
Q20UDEH/Q26UDEH/Q50UDEH/Q100UDEHCPU
4096 2048
CPU modules other than the above Not supported Not supported
MELSECNET/H remote I/O station 512 256
For example, if multiple intelligent function modules are installed to the
MELSECNET/H remote I/O station, configure the settings in GX Configurator-DA
so that the number of parameter settings for all the intelligent function modules
does not exceed the limit of the MELSECNET/H remote I/O station.
Calculate the total number of parameter settings separately for the initial setting
and for the auto refresh setting.
The number of parameters that can be set for one module in GX Configurator-DA
is as shown below.
Target module Initial setting Auto refresh setting
Q62DAN/Q62DA 1 (Fixed) 5 (Max.)
Q64DAN/Q64DA 1 (Fixed) 9 (Max.)
Q68DAVN/Q68DAIN/Q68DAV/Q68DAI 1 (Fixed) 17 (Max.)
Example) Counting the number of parameter settings in Auto refresh setting
To Next Page
Loading...
