Mitsubishi Electric Q62DAN - Page 86

5 - 9 5 - 9
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
(b) Text files
A text file can be created by clicking the Make text file
button on the Initial
setting, Auto refresh setting, or Monitor/Test window.
The text files can be utilized to create user documents.
QCPU
RUN.
ERR.
USER.
BAT.
BOOT.
RS-232
USB
Q25HCPU
MODE.
A
GX Developer/
GX Configurator-DA
Disk
Project Project
AA
B
Personal computer
A : Intelligent function module parameters
B : Data saved by "Make text file"
1)
2)
3)
Figure 5.1 Correlation chart for data created with the utility package
Steps 1) to 3) shown in Figure 5.1 are performed as follows:
1) From GX Developer, select:
[Project] [Open project] / [Save]/ [Save as]
2) On the intelligent function module selection screen of the
utility, select:
[Intelligent function module parameter] [Open parameters] / [Save
parameters]
3) From GX Developer, select:
[Online] [Read from PLC] / [Write to PLC] "Intelligent function
module parameters"
Alternatively, from the intelligent function module selection screen of
the utility, select:
[Online]
[Read from PLC] / [Write to PLC]