5 - 22 5 - 22
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-DA)
(3) Examples of "Selection test"
The following explains the case of forcing on CH1 Output enable/disable flag
(Y1).
(a) Click the Operating condition setting
button in the Monitor/Test window.
(b) Change the setting value field for "Y01: CH1 Output enable/disable flag" to
"ON: enable".
At this point, the setting data have not been written to the D/A converter
module.
(c) Click on the field, of which setting value has been changed in step (b).
(When multiple items have been changed in operation (b), select the setting
value fields where setting values were changed, while holding down the
Ctrl
key. Multiple fields can be selected by dragging the mouse over
them.)
(d) Click the Execute test button to write the data.
After the writing is completed, the written values are displayed in the
"Current value" field.
To Next Page
Loading...
