Mitsubishi Electric QD62D - Page 109

8 - 17 8 - 17
MELSEC-Q
8 PROGRAMMING
(a) When using the functions listed below, use the following
programs.
1) When the disable count function is used
Starts the disable count function
Stops the disable count function
2) When the latch counter function is used
Turns off Counter function
execution start signal (X1026)
Executes the latch counter
function
3) When the sampling counter function is used
Turns off Counter function
execution start signal (X1026)
Executes the sampling counter
function
4) When the periodic pulse counter function is used
Turns off Counter function
execution start signal (X1026)
Executes the periodic pulse
counter function