2 - 4 2 - 4
MELSEC-Q
2 SYSTEM CONFIGURATIONS
2.2 About Use of the QD62 (E/D) with the Q00J/Q00/Q01CPU
Here, use of the QD62 (E/D) with the Q00J/Q00/Q01CPU is explained.
(1) Number of QD62 (E/D) that can be installed when the
Q00J/Q00/Q01CPU is used
See Section 2.1 concerning the number of QD62 (E/D) that can be installed
when the Q00J/Q00/Q01CPU is used.
(2) Limitations when using the Q00J/Q00/Q01CPU
To use the coincidence detection interrupt function, use the Q00J/Q00/Q01CPU
of function version B or later.
2.3 About Use of the QD62 (E/D) with the Q12PRH/Q25PRHCPU
Here, use of the QD62 (E/D) with the Q12PRH/Q25PRHCPU is explained.
(1) GX Configurator-CT
When using GX Developer to access the Q12PRH/Q25PRHCPU through the
intelligent function module on the extension base unit, GX Configurator-CT
cannot be used.
Connect a personal computer to the Q12PRH/Q25PRHCPU with a
communication path indicated below.
2
1
Main base unit
Extension base unit
1 2
Direct connection to the CPU
Connection through an intelligent function module on the main base unit
(Through Ethernet module, MELSECNET/H module, or CC-Link module)
(GX Configurator-CT cannot be used.)
To Next Page
Loading...
