Mitsubishi Electric QJ71GF11-T2 - Starting an Interrupt Program by the Rising;Falling Edge of the Specified Device; An Interrupt Cannot be Generated; Using Cyclic Data in an Interrupt Program

110
(e) Starting an interrupt program by the rising/falling edge of the specified device
Do not start an interrupt program using instructions, such as PLS and PLF, that depend on the rising/falling
edge of the specified devices because changes in devices might not be read.
Sending an interrupt request by turning on RX100 in a station in network number 7
(f) An interrupt cannot be generated
Changes in the interrupt condition device cannot be detected if the change is shorter than the transmission
delay time.
(g) Using cyclic data in an interrupt program
When an interrupt program is executed, link refresh is not performed to CPU module devices. Directly access
the link devices of the master/local module by direct access.
Ex.
PLS
J7\
X100
Since change of RX100 may not be read,
this cannot be specified as interrupt condition.