145
CHAPTER 8 FUNCTIONS
8
8.2 Transient Transmission
8.2.2 Communications with different networks
8.2.2 Communications with different networks
By presetting the routing parameters (communication route) using GX Works2, transient transmission can be
performed to stations on different networks through GX Works2.
Seamless communications are available with the following networks. ( Page 119, Section 7.8)
• Ethernet
• CC-Link IE Controller Network
• MELSECNET/H
• MELSECNET/10
• CC-Link (when using GX Works2)
● Communications can be made with stations up to eight networks apart (number of relay stations: 7).
( Page 238, Section 10.1 (1) (b))
● With GX Works2, the remote operation and clock settings cannot be set in units of groups on CC-Link IE Field Network.
Set the communication route by routing parameters in advance.
CC-Link IE Controller Network
CC-Link IE Field Network
Network No.1
Network No.2
(Relay station)
To Next Page
Loading...
