Mitsubishi Electric QJ71GF11-T2 - Executing an Instruction to All the Specified Stations; Specifying a CPU by the Target Stations CPU Type

243
CHAPTER 10 DEDICATED INSTRUCTIONS
10
10.2 Precautions for Dedicated Instructions 10.2.2 Precautions for link dedicated instructions
(a) Executing an instruction to all the specified stations
Configure the system so that the target stations have the same control CPU No.
(b) Specifying a CPU by the target station's CPU type
If the CPU No. set for the target station's CPU type is different than that of the control CPU, the instruction is
not executed (However, an error does not occur in the request source).
1 221 2 1 221 2
Set the same control CPU No.
Control CPU setting
1 221 2
1122 2
Control CPU setting
Since the control CPU of the CC-Link IE Field Network module is No.2,
the instruction to multi-CPU No.1 is not executed.
When executing a WRITE instruction
under the following conditions:
Multi-CPU No.1 (03E0
H)
Target station No.
Target station's CPU type
All stations (FF
H)