Mitsubishi Electric QJ71GF11-T2 - Access Code;Attribute Code

345
CHAPTER 10 DEDICATED INSTRUCTIONS
10
10.15 JP/GP.RIRD (Reading Data from the Target Station)
(b) Access code/attribute code
*1 Devices other than the above cannot be accessed.
To access a bit device, specify 0 or multiples of 16.
*2 When the target is a module other than the master/local module, refer to the manual for the target station for details on
access codes/attribute codes.
*3 Extension data registers after D65536 and extension link registers after W10000 cannot be specified.
Use the following link special registers (SW) to set the arrival monitoring time and number of resends. ( Page 493,
Appendix 4)
• Arrival monitoring time (RIRD/RIWT) (SW0009)
• Number of resends (RIRD/RIWT) (SW000B)
Device
*1
Name
Device type
Unit
Access code
*2
Attribute
code
*2
Bit Word
Input relay X Hexadecimal
01
H
05
H
Output relay Y Hexadecimal
02
H
Internal relay M Decimal
03
H
Latch relay L Decimal
83
H
Link relay B Hexadecimal
23
H
Timer (contact) T Decimal
09
H
Timer (coil) T Decimal
0A
H
Timer (current value) T Decimal
0C
H
Retentive timer (contact) ST Decimal
89
H
Retentive timer (coil) ST Decimal
8A
H
Retentive timer (current value) ST Decimal
8C
H
Counter (contact) C Decimal
11
H
Counter (coil) C Decimal
12
H
Counter (current value) C Decimal
14
H
Data register
*3
D Decimal
04
H
Link register
*3
W Hexadecimal
24
H
File register R Decimal
84
H
Link special relay SB Hexadecimal
63
H
Link special register SW Hexadecimal
64
H
Special relay SM Decimal
43
H
Special register SD Decimal
44
H