Mitsubishi Electric R60AD8-G - Page 153

APPX
Appendix 3 Buffer Memory Areas
151
A
A/D conversion completed flag
The A/D conversion status can be checked.
■Buffer memory address
The following shows the buffer memory address of this area.
■A/D conversion completed flag status
When the first A/D conversion is completed in the channel where the A/D conversion is enabled, the flag turns to A/D
conversion completed (1). 'A/D conversion completed flag' (XE) turns on when the conversion of all the channels where the A/
D conversion is enabled is completed.
■Clearing A/D conversion completed flag
Turning on and off 'Operating condition setting request' (Y9) turns the flag back to the default (During A/D conversion or
unused (0)), and when the first A/D conversion has completed, the flag turns to A/D conversion completed (1) again.
Level data 0 to 9
This area stores data to be monitored when a level trigger of the logging function is used. Ten types of data are available:
'Level data 0' (Un\G90) to 'Level data 9' (Un\G99). Use the area to generate triggers while monitoring the values of devices
other than the A/D converter module.
For details on the logging function, refer to the following.
Page 61 Logging Function
■Buffer memory address
The following shows the buffer memory address of this area.
■Setting range
The setting range is from -32768 to 32767.
■Default value
The default value is 0 for all channels.
• 0: During A/D conversion or not used, 1: A/D conversion completed
• b8 to b15 of the R60AD8-G are fixed to 0.
Buffer memory name CH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
A/D conversion completed flag 42
A/D conversion completed flag (in Q compatible
mode)
10 
Buffer memory name 0 1 2 3 4 5 6 7 8 9
Level data 90 91 92 93 94 95 96 97 98 99
Level data (in Q
compatible mode)
1072 1073 1074 1075 1076 1077 1078 1079 1080 1081
CH16 CH15 CH14 CH13 CH12 CH11 CH10 CH9 CH1CH2CH3CH4CH5CH6CH7CH8
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b0b1b2b3b4