154
APPX
Appendix 3 Buffer Memory Areas
Condition target channel setting [n]
Set a channel where an interrupt is detected.
*1 When the R60AD8-G is used, only 0 to 8 can be set.
When a factor for the channel specification is set to 'Condition target setting [n]' (Un\G232 to Un\G247), an interrupt factor in
the channel set by this area is monitored. When a factor of the input signal (X) is set, the setting in this area is ignored.
If a value other than the above is set, a condition target channel setting range error (error code: 182H) occurs.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is All channels (0) for all channels.
Setting value
*1
Setting content
0 All channels
1 CH1
2 CH2
3 CH3
4 CH4
5 CH5
6 CH6
7 CH7
8 CH8
9 CH9
10 CH10
11 CH11
12 CH12
13 CH13
14 CH14
15 CH15
16 CH16
Buffer memory name 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Condition target channel
setting [n]
264 265 266 267 268 269 270 271 272 273 274 275 276 277 278 279
Condition target channel
setting [n] (in Q compatible
mode)
4160 4161 4162 4163 4164 4165 4166 4167 4168 4169 4170 4171 4172 4173 4174 4175
To Next Page
Loading...
